...
Name | Quantity | Notes |
---|---|---|
Crank | 2 | |
Gear holder | 1 | |
knurled shaft (M2) | 2 | |
metal shaft stopper | 3 | |
gear M=0.5 22mm (42-2A) | 1 | Need to drill by yourself |
M2 nut | 6 | |
M2 x 10 bolt | 6 | |
folded cross plate | 2 | |
plastic shaft stopper (M2, orange) | 4 | |
shaft (2mm x 70mm) | 1 | |
shaft (2mm x 30mm) | 2 | Used for fixing gear and gear holder when drill the gear |
Hexagonal key (1.27mm) | 1 |
...
Assemble the main shaft (with new crank and gear) to the main body
- Place the assembled shaft onto the main body
- Adjust position of the gear to align with the motor and tighten the screw on the metal shaft stopper in the gear holder. Note that the motor must be pushed towards the inside as much as possible, so as not be block the crank
...
- Adjust the bite position of the gear and the motor suitable before installing the screws to ensure the gear is stable.
Completed